The SLW-54C Gabion Box Machine combines five-axis CNC weaving with remote monitoring and diagnosis support. These functions help technical personnel investigate operating conditions and maintenance issues. Anping Weaver Wire Mesh Equipment Manufacturing Co., Ltd. also provides customizable software and installation support as part of the agreed production solution, connecting equipment capability with practical factory operation.
|
Drive and control |
Specification |
Service and software |
Specification |
|
Servo sets |
5 |
Software |
In-house developed |
|
Servo rating |
15 kW each |
Customization |
Logic, language, reports |
|
Motor brand |
HCFA |
Diagnosis |
Remote support |
|
Control |
XINJE PLC + HMI |
Monitoring |
Remote capability |
The Gabion Box Machine uses XINJE PLC and HMI control with software developed in-house. Interface language, operating logic and reports can be tailored to the agreed requirements. Remote service complements this control environment, while the extent of monitoring and support should be established in the technical scope supplied to the customer.
A simplified transmission reduces the number of traditional mechanical connections and wear points. Automatic lubrication is listed among the standard inclusions, along with a take-up shaft and warping machine on the production-line sheet. The Gabion Box Machine still requires regular inspections, and the final accessory list should be confirmed against the supplied configuration rather than extended by assumption.
Five coordinated servo drives manage the repeating movements used to position wires, form twists and advance the netting. This process creates a connected hexagonal mesh pattern. The Gabion Box Machine supports different twist arrangements, including three twists and five twists, together with long and short patterns. Operators set twist length through the HMI within the stated 40–70 mm range.
Check the required wire and mesh dimensions, install matching tooling and prepare the feed arrangement. Trial weaving verifies the setup before the batch begins. Woven mesh is then collected and processed using the specified downstream machines. Available line equipment covers wire preparation, spring making, bending, shrinking and rolling, and mesh cutting, with the final combination based on production needs.
Begin with physical readiness checks and a review of HMI settings. Run a controlled trial and inspect both openings and twisted sections. During production, keep an orderly record of the order specification and any observed fault indications. Clear, specific information about the operating condition helps technicians assess a problem when remote diagnosis or further service support is needed.
Stop safely when abnormal movement, wire feeding or mesh formation appears. Follow isolation procedures before entering hazardous areas or making physical adjustments. Remote advice does not make it safe to work on moving machinery. Confirm that the cause has been addressed and inspect fresh trial mesh before restarting the batch; avoid repeated restarts without understanding the fault.
The standard maximum width is 5.4 m and maximum galvanized wire diameter is 4 mm. Typical openings include 60 × 80, 80 × 100 and 100 × 120 mm, with matching tooling required. The stated maximum output of 1000+ m²/hour is conditional on the wire, mesh, process and site conditions, so evaluate it against the intended production specification.
The SLW-54C Gabion Box Machine supplies mesh for downstream gabion products used in river training, slope protection, road retaining works and ecological restoration. Its service functions support continued equipment use alongside normal maintenance. Customers can discuss operating language, reports, auxiliary equipment and installation requirements with the manufacturer when defining a suitable weaving or complete-line arrangement.
The application gallery presents the supplied machinery photographs, covering the weaving area, controls and factory layout alongside an equipment display with finished mesh.
|
Gabion Box Machine Installation at a Customer’s Factory |
Showroom Display of Gabion Box Machine with Woven Mesh |
|
Gabion Box Machine in Operation at a Customer’s Factory |
Factory Setup of Gabion Box Machine with Wire Payoff Stands |
Contact Us at Any Time